debugging update issues
Posted: Thu Aug 18, 2005 1:50 pm
Is anyone else having problems loading the updates...
Whats happening with mine and only since the xpac release is ...
it goes fine until it gets to the connect screen where it shows % loaded ...
it then goes for a bit then hangs sometimes severe enough that i must reboot the computer hard (power off/on) as it has locked the machine i can restart and continue a bit further usually only getting +10% each time
sometimes it will halt saying my client_portal.dat is corrupted in which case i must re-install my app from the disc set....
i did finally finish loading a bit at a time but i dont want to go thru this excerse each month...any thoughts?
last time i spoke with turbine support the guy said it was my router ...and we changed a few settings then but its seems to come back....
if anyone has similar experiences or any ideas would be appreciated..
ps i run a max out machine 1 gb , nivia 6800 , cable highspeed with 5 meg line..runs and updates ac2 fine....just not the new version of ac1
Whats happening with mine and only since the xpac release is ...
it goes fine until it gets to the connect screen where it shows % loaded ...
it then goes for a bit then hangs sometimes severe enough that i must reboot the computer hard (power off/on) as it has locked the machine i can restart and continue a bit further usually only getting +10% each time
sometimes it will halt saying my client_portal.dat is corrupted in which case i must re-install my app from the disc set....
i did finally finish loading a bit at a time but i dont want to go thru this excerse each month...any thoughts?
last time i spoke with turbine support the guy said it was my router ...and we changed a few settings then but its seems to come back....
if anyone has similar experiences or any ideas would be appreciated..
ps i run a max out machine 1 gb , nivia 6800 , cable highspeed with 5 meg line..runs and updates ac2 fine....just not the new version of ac1
